SECTION BENDING UNEQUAL ANGLE

Equal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

Bending Angle Profiles

Description

Equal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

Depending upon your unique project requirements, Profile Bending angle bending may be performed on a variety of materials, including carbon steelstainless steelaluminumtitanium, and copper.

Unequal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

For angle bending with heel in, the radius or diameter is usually specified as measured from the inside apex of the angle.

For angle bending with heel out, the radius or diameter is usually specified as measured from the outside apex of the angle.

When bending angles heel up, the radius or diameter is usually specified as measured from the apex of the angle.

Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.

Selection table of BIT angle bending machine for bending unequal angle

angle bending machine
Angle bending machine
ModelToe InToe Out
Spec(mm)Min DIA(mm)Spec(mm)Min DIA(mm)
W24S-1680 × 80 × 10100080 × 80 × 101500
W24S-45100 × 100 × 121200100 × 100 × 122000
W24S-75120 × 120 × 121500120 × 120 × 122000
W24S-140150 × 150 × 81500150 × 150 × 82500
W24S-180140 × 140 × 141800140 × 140 × 143000
W24S-250180 × 180 × 123000180 × 180 × 124000
W24S-320200 × 200 × 204000200 × 200 × 204500
W24S-400200 × 200 × 284000200 × 200 × 286000
W24S-500200 × 200 × 304500200 × 200 × 308000
W24S-600200 × 200 × 304500200 × 200 × 308000
w24s profile bending machine
W24 SERIES

All W24 series section bending machine are driven by hydraulic motor (up to 9), powerful bending ability. Standard machine section modulus: 16CM3-600CM3. Can bend various types of materials into an arc or a circle.It can bend copper, carbon steel, stainless steel and aluminum profiles.
Angle, channel, beam, flat bar, round & square bar,pipe,square tube.

aluminum profile bending machine
B CNC SERIES

CNC aluminum profile bending machine
CNC control. Accuracy is as high as ≤0.01mm. 
Can be bent in various shapes (3-D graphics, C-shaped, U-shaped, full circle, ellipse, multiple radii combination shapes, etc.)
Suitable for bending of aluminum profiles for automobiles, doors and windows

section bender
section bender
MS SERIES

Small section bender (section bending machine), with manual and semi-hydraulic drives, can bend profiles other than beam.
Cheap price, first choice for small factories

profile bending

Section bending methods of metal profiles and the corresponding bending capabilities of various BIT models.