Skip to content

Flange Roll Forming Machine

Bending Angle Profiles

Section Bending Unequal Angle

Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.

angle bending machine

bending angle iron

What is the difference between Angle Roll Bending and Angle Bending ?
How to reduce the flat part in bending angle?
Five Factors That Influence the Bending Angle Iron Process.
Greatest Load Bearing Aspects of angle iron.
Layman’s Explanation of angle iron’s Strengths and Weaknesses.

Profile Bending Machine

W24S-100 4-roll Hydraulic Profile Bending Machine

This model W24S-100 belongs to the old model of BIT, which has now been replaced by W24S-140. This is because the processing capacity of the 140 profile bending machine covers the processing range of the 100 model.

angle flange forming

Attention point of cold bending of angle flanges

Cold bending is done on machines commonly called profile bending machine (also called angle roller or section benders) .

These machines might have three or four rolls that induce the curvature of the steel sections as they pass through the tooling.

Angle bending machine

Unequal angle bending machine

Unequal angle bending machine ( angle flange bending machine) and angle rolling machine are two names of the same machine Unequal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

angle bending machine

Angle roller

how do angle iron roller work?
difference of the angle roller.
what you need to know before bending an angle iron?
five bending methods of angle iron.
five factors that influence the bending angle iron process.
what is angle flange ?
how to bend an angle flanges with a angle roll?
how to minimize the unbent flat of roll bending angle iron?

Flange bending machine

Hydraulic flat bar bending machine

Many customers refer to the flat bar bending machine as a flat bar rolling machine. Somebody also called flat bar bender or flat bar roller.

Many Chinese customers refer to the flat steel bending machine as a flange roll forming machine. For BIT, it is just an ordinary section bending machine for bending flat steel.

Sturdy body and strong section bending ability, BIT section bending machine can bend higher strength stainless steel bar like flat iron bar.

tee bending machine

Tee bending machine

\In the picture, the BIT section bending machine uses the function of a tee bending machine, and it is bending a high-strength stainless steel tee.
A quicker and more effective way to straighten tees is with a BIT serise section bending machine (also called a “profile bending machine,” or an “section bender.”). The curved steel tee is run through large rollers with smaller calibrating rollers until it is straight.