It’s worth a mention firstly that there are two common terms used in industry, tube bending and pipe bending. Tube is measured by the outside diameter whereas pipe is measured by the inside diameter. Pipe sizing refers to the nominal inside diameter, sometimes called nominal bore, rather than the actual inside diameter.
Tube is bent around a fixed radius die with a mandrel insert in to prevent it from collapsing during bending. The tube or pipe is clamped against the die and this is then rotated whilst the pressure die moves in a straight linear motion. This is the most common form of bending.
Shipping packaging The profile bending machine with section bending capacity less than 250CM3 is loaded in a 20-foot container. Warning:Must read before debugging Debugging PREPARATION BEFORE DEBUGGING Please check all connected and clamping parts. Please check the angle bender hydraulic oil level, and check if the lubrication is okay. Please check the voltage of electricity. […]
W24S-500 profile bending machine is the large three-roll section bending machine.
Equipped with BIT’s unique section bending combination mold, which can bend different profiles with the greatest precision and minimal deformation. BIT section bending combination molds are easy to use and a quick-change configuration that guarantees quick replacement, which is very valuable for time-saving customers, because they often bend profiles of different sizes and types.
W24S-320 profile bending machine is a large section bending machine with a volume of 3000×3000×2800mm and a weight of 30T.
The profile bending machine in the picture is ordered by a factory to bend I-Beame and rectangular tubes.