The profile bending machine can be transported in horizontal position by any means of transportation under the condition that road traffic regulations are followed.
During transport, the machine needs to be secured against movement or damage e.g. by means of fastening belts.
First start During the first start-up, the profile bending machine should run for about 2 minutes without rolling any material-the bending roller should be moved by the foot controller. During this period, check whether the profile bending machine is running smoothly, without impact, and no friction or scratching sound is found. If the section bender […]
The section bending machine (WQJ Series) needs to be installed on a level and hardened surface to ensure its stability. Electric The electrical equipment/power supply must be connected via a 5 x 2.5 mm2 copper cable with a voltage of 3 x 400 V and protected by a fuse with delay characteristics (Type C fuse) […]
Because the three-roller Angle bending machine uses a mechanical three-roller symmetry structure, the two lower rollers perform the main movement of the rotation, and the upper roller performs the vertical elevating movement, so the design uses the “handle-drive screw-drive nut-slider” The transmission method converts the rotation of the handle into the vertical lifting movement of […]
The working (rolling) system of the profile bending machine consists of two guide rolls and one top, active bending roll whose working position can be adjusted by means of a rotating handle / arm. The WQJ-400 equipped with this handle for adjusting the upper roll position and the WQJY-400 is equipped with an hydraulic system […]
Long standstills In the case of a long break in operation, the machine has to be stored in a dry room on a levelled surface. The power cable needs to be disconnected from the power socket, wound up and securely stored together with the machine. Check the protective paint coat, clean damaged spots and coat […]
WQJY-50 profile bending machine is a small manual profile bending machine, which can be used for bending angle (angle bending machine).
Its volume and weight are very small, and of course its bending ability is also very small. Can not allowed to bend channel and H&I beam profiles.
WQJ-400 is a small manual symmetrical profile bending machine. Can bend flat bar, angle, round bar, pipe (tube) and Tee profiles.
